shock load การใช้

• :: Ceramics are generally too brittle to absorb shock loads without damage.
• Its main characteristic is a clutch that assists in braking under a shock load.
• The rope should be replaced immediately if any evidences of shock load have been found.
• In addition, ropes should avoid sudden load, as a shock load can destroy a rope easily.
• But the shock load caused the wind instruments at the top of the mast to go haywire.
• The forcing function in the equation is the accelerative shock load delivered to the pelvis by the event.
• The 90-feet catenary surge chain used to damp shock loads in the towing line was also deemed insufficient.
• The bombs, if you drop them in the right spot, provide enough of a shock load to trigger an avalanche.
• Therefore, here significant shock loads are applied to the variator pulley during transmission ratio change that increases the transmission diameter.
• Removing those defects by polishing makes the axe much stronger, and able to withstand impact and shock loads from use.
• Laptops ( and their flying disk heads and platters ) will routinely survive the sorts of shock loads imposed by turbulence.
• There are a limited number of applications that involve repeated shock loads to the knot and in these 4 wraps are usually sufficient.
• All mission-essential equipment on board military surface ships and submarines must be qualified for underwater shock loads caused by depth charges, naval mines, missiles, and torpedoes.
• This ring is mounted onto a centre disc, and springs between the two reduce shock loads and allow the small movement needed to accommodate joints and curves.
• This property makes the material suitable for use in applications that demand very high dimensional stability, such as metrology instruments, and for products that need to withstand high thermal-shock loads.
• The related mortising axe or "'Bec d'ane "'( donkey's nose ) is similar, but single-sided and is forged and tempered to survive the shock loads of swinging as an axe.
• Hydraulic breakers usually use a hydraulic motor driving a sealed pneumatic hammer system, as a hydraulic hammer would develop a low strike speed and transfer unacceptable shock loads to the pump system.
• For example, vessels not completely mixed ( i . e . plug flow reactors ) are more susceptible to the effects of shock loads which may cause cell lysis and release of soluble microbial products.
• It was stronger than the tiles and was also used around the socket of the forward attach point of the orbiter to the External Tank to accommodate the shock loads of the explosive bolt detonation.
• It is based on the concept that a blast shock load is essentially a high-pressure front that moves out radially and decays very quickly-because blast falloff is thus often more shrapnel mitigates this effect if present.